Then register for ClubRoadster!!!!!!!!!! lol jk
1991.5 (long nose crank) Classic Red. $16,000.00
Does not currently run as it is in the midst of a total restoration. Decided to go a different route with my 'fun money'. Feel free to check out my build thread for additional details. Every part here has less than 50' of manual pushing in and out of the garage on them.
I have around $13,000 in the engine and tranny.
Mercury VC with AN fittings for oil catch can.
Antique Mazda oil cap
New plugs and wires via Moss
Jenvey IRTBs with blue Ford injectors and accessories needed to complete.
Integral cams. Stage 3 in and stage 2 out
All internals from 949Racing.
Bored to 79mm with a Cometic head gasket.
10.6:1 pistons, rods, bearings via 949Racing
Polished crank
ISC Racing oil pan powder coated to match VC
TODA adj cam gears
Racing Beat exhaust header
Mishimoto radiator and dual fan set-up to include hoses
No HVAC, no power steering
Gates belt, rollers from 949Racing
New Bosch alternator
Every bolt new via rebuild. Nothing was reused.
Transmission completely rebuilt.
St. May Shotgun exhaust with all new Poly mounts via Corksport. Came from phatmiata and according to him has around 1000 miles on it. Flawless.
949Racing braces installed.
Torsen 3.9 LSD
XIDA-S 700f/400r with helper springs.
949Racing 6ULs, 15X9, 225/45/15 R-S3s, H&R 5mm spacers on all four corners, 949Racing lugs.
Barchetta bumper. Around 50 made in the early '90's and this is the only one in the US and was over $3000 to get. TRAP 120mm lip.
You get the idea...
Tons of little things like KGW short shift kit, KGW rear view mirror, ZOOM side mirrors (passenger side has long arm option), N20 kit, hard top. Frog arms are already installed behind the fenders. Roll bar powdercoated to match VC and silver harness bar. ZOOM center console and side skirts are already paid for and will be included once I get them.
There is no rear bumper as I was planning on getting the Simpson shorty. No headlamps as I refused to believe I couldn't find Hyashi lights. Car will need work to bring to life... MSPNP, interior, TLC.
Also will include the gauge faces revlimiter made. As well as every other little trinket I've managed to get along the way.
GV lights have a small chip on the drivers side but I was planning on molding in ala Mr. Woolery so never worried about it. Will also include the #2/10 Garage Woolery GV rings.
1. U-Haul is cheap heading out of San Antonio due to the influx of inbound military.
2. I'm willing to pick you up at the airport and get you to U-Haul.
3. Will help load up on trailer.
Please, no 'dibbing' etc on parts. If I part out, a thread for that will be made. I have a mental dib for my friends should I decide to part so don't bother wasting space here.
PM for any additional details that are not here or in my build thread.